Plex lifter bugs

[25hz]

1. If you stand too close to the lifter block when it's moving, the platform rises faster than you and you fall through the platform.

2. If you pan the camera up while on the platform, you fall through it.

3. If you pan the camera around left or right, you fall through the platform.

4. If you stand to far out on the platform while moving, you fall through it.

5. You clip and fall through the small gap between the edge of the platform and the closest block.

Lots of problems.

 

[Jack Caos]

you can make the platform go through blocks on the edge, so you dont have gaps

 

[25hz]

I am aware of that, but making the platform hole only 3 x 3 means you have to stand close to the lifter, which can cause you to fall through the platform itself. Also, more importantly, why make the platform with a gap in the first place? Why not make it even block widths wide? What\'s the logic behind leaving a gap in the first place (considering all the platform bugs)?