Not sure if bug or in need of fine tuning...

    Joined
    Jan 20, 2014
    Messages
    17
    Reaction score
    17
    I built a space station with a reactor for about 170k reactor blocks, and about 350k stabilizers at a distance ok 200 meters from the station it was stabilized until I updated to 0.200.148. Now I have to go out some 600 meters for one stabilizer to register. If I want to stabilize efficiently I'll need to go all the way out to 1107 meters out lol. Not sure if this is a bug, intended, or in need of fine tuning.
     
    Joined
    Feb 27, 2014
    Messages
    1,074
    Reaction score
    502
    • Purchased!
    • Legacy Citizen 4
    • Top Forum Contributor
    Dev builds are well knowen to be quite bugged and incomplete or under constant changes, sounds like thats probably the cause.
     
    Joined
    Jul 5, 2015
    Messages
    252
    Reaction score
    51
    I wouldn't build anything large and permanent in any dev build, since nearly anything can change in them without notice, due to the features being in a constant state of flux. My own dev build setup is just a small station and a few cobbled together tester ships.
     

    AndyP

    Customer Experience Manager
    Joined
    Aug 15, 2013
    Messages
    1,199
    Reaction score
    264
    • Schine
    • Wired for Logic
    There were several config changes in the dev-build.
    You may want to scale down your reactor then.
     
    Joined
    Jan 20, 2014
    Messages
    17
    Reaction score
    17
    I'll just leave the stabilizers as an unattached unit until the it moves into a normal release. The stabilizers are easier to move than the reactors.